PRESSING INSTRUCTIONS

DTF is the process in which designs are printed directly onto a film. The design is able to be applied to almost any substrate/material and can go on any color item.

Every Heat Press is different, temps and pressure are not always accurate or even so adjusting for your individual press is necessary, we highly recommend a heat gun. WE ARE NOT RESPONSIBLE FOR ANY PRESSING ISSUES DUE TO INACCURATE TEMPERATURE OR PRESSURE.

Direct To Film Transfers

  • High Pressure (8-9 manual) 60PSI Automatic
  • Warm Peel
    • Cotton/Poly Blends - Temp: 325, Time: 20 sec
    • Tri Blend - Temp: 325, Time: 20 sec
    • 50/50 - Temp: 325, Time: 20 sec
  • Double Press With Parchment Paper For Best Results

 Puff Transfers

  • Medium Pressure (6-7 manual) 
  • Peel Instantly 
    • Cotton/Poly Blends - Temp: 350, Time: 8 sec

Chenille Patches

  • 320 Degrees
  • Cover with teflon
  • Pre press for 7 seconds to remove wrinkles and moisture;
  • Press for 20 seconds, turn inside out and press underneath the patch for 20 seconds to ensure good adhesion

  • **May add liquid stitch for an extra layer of adhesion.

 Leather Hat Patches

Our patches are 100% leather and are shipped to you with no adhesive backing attached. For attaching leather patches we highly recommend Liquid Stitch brand fabric adhesive. This can be found at most craft stores, Amazon, and Walmart stores. Simply follow the directions and your patches will be securely attached. 

Sublimation

Please do your research and understand how the process of sublimation works. It requires a polyester material and light colored material. Depending on your shirt material you may need to adjust your heat, some fabrics scorch easier than others.

  • 385-400 degrees;
  • Pre press for 7 seconds;
  • Press for 45-60 seconds.
  • Cover with parchment paper, thread shirt or place parchment paper inside shirt to prevent dye migration.

UV DTF Wraps

No heat required 

 

 

We are not responsible for damaged transfers after you have pressed them. Please make sure you are knowledgable on your heat, pressing pressure and peeling technique. This includes using non-commercial grade heat presses or irons to try and use our transfers. 

 

We recommend using a heat gun to verify your heat temperature and the use a pressure test prior to pressing. 

Items should not be washed for at least 48 hours. Please allow the shirt to completely set with the item. You can view further care instructions for both transfers and pressed garments here.  

Due to the many variations in monitors and browsers, colors may appear different on different monitors. Computer monitors are not all calibrated equally and color reproduction on the Internet is not precise.